- History 1
- Examples 2
- See also 3
- References 4
- Sources 5
In their original Greek version, Doric columns stood directly on the flat pavement (the stylobate) of a temple without a base; their vertical shafts were fluted with 20 parallel concave grooves; and they were topped by a smooth capital that flared from the column to meet a square abacus at the intersection with the horizontal beam (architrave) that they carried. The Parthenon has the Doric design columns. It was most popular in the Archaic Period (750-480 BC) in mainland Greece.
Pronounced features of both Greek and Roman versions of the Doric order are the alternating
The architecture followed rules of harmony. Since the original design came from wooden temples and the triglyphs were real heads of wooden beams, every column had to bear a beam which lay across the centre of the column. Triglyphs were arranged regularly; the last triglyph was centred upon the last column (illustration, right: I.). This was regarded as the ideal solution which had to be reached.
Changing to stone cubes instead of wooden beams required full support of the architrave load at the last column. At the first temples the final triglyph was moved (illustration, right: II.), still terminating the sequence, but leaving a gap disturbing the regular order. Even worse, the last triglyph was not centered with the corresponding column. That “archaic” manner was not regarded as a harmonious design. The resulting problem is called the doric corner conflict. Another approach was to apply a broader corner triglyph (III.) but was not really satisfying.
Because the metopes are somewhat flexible in their proportions, the modular space between columns (“intercolumniation”) can be adjusted by the architect. Often the last two columns were set slightly closer together (corner contraction), to give a subtle visual strengthening to the corners. That is called the “classic” solution of the corner conflict (IV.). Triglyphs could be arranged in a harmonic manner again, and the corner was terminated with a triglyph. However, final triglyph and column were often not centered.
The Temple of the Delians is a “peripteral” Doric order temple, the largest of three dedicated to Apollo on the island of Delos. It was begun in 478 BC and never completely finished. During their period of independence from Athens, the Delians reassigned the temple to the island of Poros. It is “hexastyle”, with six columns across the pedimented end and thirteen along each long face. All the columns are centered under a triglyph in the frieze, except for the corner columns. The plain, unfluted shafts on the columns stand directly on the platform (the stylobate), without bases. The recessed “necking” in the nature of fluting at the top of the shafts and the wide cushionlike echinus may be interpreted as slightly self-conscious archaicizing features, for Delos is Apollo's ancient birthplace. However, the similar fluting at the base of the shafts might indicate an intention for the plain shafts to be capable of wrapping in drapery.
A classic statement of the Greek Doric order is the Temple of Hephaestus in Athens, built about 447 BC. The contemporary Parthenon, the largest temple in classical Athens, is also in the Doric order, although the sculptural enrichment is more familiar in the Ionic order: the Greeks were never as doctrinaire in the use of the Classical vocabulary as Renaissance theorists or neoclassical architects. The detail (illustration, left), part of the basic vocabulary of trained architects from the later 18th century onwards, shows how the width of the metopes was flexible: here they bear the famous bas-relief sculptures of the battle of Lapiths and Centaurs.
In the Roman Doric version (illustration, left), the height of the entablature has been reduced. The endmost triglyph is centered over the column rather than occupying the corner of the architrave. The columns are slightly less robust in their proportions. Below their caps, an astragal molding encircles the column like a ring. Crown moldings soften transitions between frieze and cornice and emphasize the upper edge of the abacus, which is the upper part of the capital. Roman Doric columns also have moldings at their bases and stand on low square pads or are even raised on plinths. In the Roman Doric mode, columns are not invariably fluted. Since the Romans dropped the request of the triglyph covered corner, now both columns and triglyphs could be arranged in equidistant order again and well centered together. The architrave corner needed to be left “blank” (illustration, right, V.).
The Roman architect Vitruvius, following contemporary practice, outlined in his treatise the procedure for laying out constructions based on a module, which he took to be one half a column's diameter, taken at the base. An illustration of Andrea Palladio's Doric order, as it was laid out, with modules identified, by Isaac Ware, in The Four Books of Palladio's Architecture (London, 1738) is illustrated at Vitruvian module.
When Greek Revival architecture was introduced at the beginning of the 19th century, the Greek Doric order had not previously been widely used. The first engraved illustrations of the Greek Doric order dated to the mid-18th century. Its appearance in the new phase of Classicism brought with it new connotations of high-minded primitive simplicity, seriousness of purpose, noble sobriety, and, in the United States, republican virtues. In a customs house, Greek Doric suggested incorruptibility; in a Protestant church a Greek Doric porch promised a return to an untainted early church; it was equally appropriate for a library, a bank or a trustworthy public utility (illustration, left).
According to Vitruvius the height of Doric columns is six or seven times the diameter at the base. This gives the Doric columns a shorter, thicker look than Ionic columns, which have 8:1 proportions. It is suggested that these proportions give the Doric columns a masculine appearance, whereas the more slender Ionic columns appear to represent a more feminine look. This sense of masculinity and femininity was often used to determine which type of column would be used for a particular structure.
- Perry's Victory and International Peace Memorial in Put-in-Bay, Ohio, is the world's tallest and most massive Doric column at 352 feet (107 m).
- Lord Hill's Column, Shrewsbury, England, is a Doric column standing at 133 feet 6 inches (40.69 m).
- "...they measured a man's foot, and finding its length the sixth part of his height, they gave the column a similar proportion, that is, they made its height, including the capital, six times the thickness of the shaft, measured at the base. Thus the Doric order obtained its proportion, its strength, and its beauty, from the human figure." (Vitruvius, iv.6) "The successors of these people, improving in taste, and preferring a more slender proportion, assigned seven diameters to the height of the Doric column." (Vitruvius, iv.8)
- Labeled Doric Column
- Sir John Summerson, The Classical Language of Architecture Revised edition, 1980 (W.W. Norton)
- James Stevens Curl, Classical Architecture: An Introduction to Its Vocabulary and Essentials, with a Select Glossary of Terms
- Georges Gromort, The Elements of Classical Architecture
- Alexander Tzonis, Classical Architecture: The Poetics of Order (Alexander Tzonis website)