Telemetry is the highly automated communications process by which measurements are made and other data collected at remote or inaccessible points and transmitted to receiving equipment for monitoring. The word is derived from Greek roots: tele = remote, and metron = measure. Systems that need external instructions and data to operate require the counterpart of telemetry, telecommand.
Although the term commonly refers to wireless data transfer mechanisms (e.g., using radio, ultrasonic, or infrared systems), it also encompasses data transferred over other media such as a telephone or computer network, optical link or other wired communications like phase line carriers. Many modern telemetry systems take advantage of the low cost and ubiquity of GSM networks by using SMS to receive and transmit telemetry data.
A telemeter is a device used to remotely measure any quantity. It consists of a sensor, a transmission path, and a display, recording, or control device. Telemeters are the physical devices used in telemetry. Electronic devices are widely used in telemetry and can be wireless or hard-wired, analog or digital. Other technologies are also possible, such as mechanical, hydraulic and optical.
- History 1
- Meteorology 2.1
- Oil and gas industry 2.2
- Space science 2.3
- Motor racing 2.4
- Agriculture 2.5
- Water management 2.6
- Swimming Pools 2.7
- Defense, space and resource exploration 2.8
- Rocketry 2.9
- Flight testing 2.10
- Military intelligence 2.11
- Energy monitoring 2.12
- Resource distribution 2.13
- Medicine/Healthcare 2.14
- Fishery and wildlife research and management 2.15
- Retail 2.16
- Law enforcement 2.17
- Energy providers 2.18
- Falconry 2.19
- Testing 2.20
- Communications 2.21
- International standards 3
- See also 4
- References 5
- External links 6
Telemetering information over wire had its origins in the 19th century. One of the first data-transmission circuits was developed in 1845 between the Russian Tsar's Winter Palace and army headquarters. In 1874, French engineers built a system of weather and snow-depth sensors on Mont Blanc that transmitted real-time information to Paris. In 1901 the American inventor C. Michalke patented the selsyn, a circuit for sending synchronized rotation information over a distance. In 1906 a set of seismic stations were built with telemetering to the Pulkovo Observatory in Russia. In 1912, Commonwealth Edison developed a system of telemetry to monitor electrical loads on its power grid. The Panama Canal (completed 1913–1914) used extensive telemetry systems to monitor locks and water levels.
Wireless telemetry made early appearances in the radiosonde, developed concurrently in 1930 by Robert Bureau in France and Pavel Molchanov in Russia. Mochanov's system modulated temperature and pressure measurements by converting them to wireless Morse code. The German V-2 rocket used a system of primitive multiplexed radio signals called "Messina" to report four rocket parameters, but it was so unreliable that Wernher von Braun once claimed it was more useful to watch the rocket through binoculars. In the US and the USSR, the Messina system was quickly replaced with better systems (in both cases, based on pulse-position modulation).
Early Soviet missile and space telemetry systems which were developed in the late 1940s used either pulse-position modulation (e.g., the Tral telemetry system developed by OKB-MEI) or pulse-duration modulation (e.g., the RTS-5 system developed by NII-885). In the United States, early work employed similar systems, but were later replaced by pulse-code modulation (PCM) (for example, in the Mars probe Mariner 4). Later Soviet interplanetary probes used redundant radio systems, transmitting telemetry by PCM on a decimeter band and PPM on a centimeter band.
Telemetry has been used by weather balloons for transmitting meteorological data since 1920.
Oil and gas industry
Telemetry is used to transmit drilling mechanics and formation evaluation information uphole, in real time, as a well is drilled. These services are known as Measurement while drilling and Logging while drilling. Schlumberger's Pulse technology is an example of this. Tools like SlimPulse, PowerPulse, TeleScope, etc. use this methodology to send information acquired thousands of feet below ground, while drilling, uphole to the surface sensors and the demodulation software. The pressure wave (sana) is translated into useful information after DSP and noise filters. This information is used for Formation evaluation, Drilling Optimization, and Geosteering.
Telemetry is used by manned or unmanned spacecraft for data transmission. Distances of more than 10 billion kilometres have been covered, e.g., by Voyager 1.
Telemetry is a key factor in modern motor racing, allowing race engineers to interpret data collected during a test or race and use it to properly tune the car for optimum performance. Systems used in series such as Formula One have become advanced to the point where the potential lap time of the car can be calculated, and this time is what the driver is expected to meet. Examples of measurements on a race car include accelerations (G forces) in three axes, temperature readings, wheel speed, and suspension displacement. In Formula One, driver input is also recorded so the team can assess driver performance and (in case of an accident) the FIA can determine or rule out driver error as a possible cause.
Later developments include two-way telemetry which allows engineers to update calibrations on the car in real time (even while it is out on the track). In Formula One, two-way telemetry surfaced in the early 1990s and consisted of a message display on the dashboard which the team could update. Its development continued until May 2001, when it was first allowed on the cars. By 2002, teams were able to change engine mapping and deactivate engine sensors from the pit while the car was on the track. For the 2003 season, the FIA banned two-way telemetry from Formula One; however, the technology may be used in other types of racing or on road cars.
Most activities related to healthy crops and good yields depend on timely availability of weather and soil data. Therefore, wireless weather stations play a major role in disease prevention and precision irrigation. These stations transmit parameters necessary for decision-making to a base station: air temperature and relative humidity, precipitation and leaf wetness (for disease prediction models), solar radiation and wind speed (to calculate evapotranspiration), water deficit stress (WDS) leaf sensors and soil moisture (crucial to irrigation decisions).
Because local micro-climates can vary significantly, such data needs to come from within the crop. Monitoring stations usually transmit data back by terrestrial radio, although occasionally satellite systems are used. Solar power is often employed to make the station independent of the power grid.
Telemetry is important in water management, including water quality and stream gauging functions. Major applications include AMR (automatic meter reading), groundwater monitoring, leak detection in distribution pipelines and equipment surveillance. Having data available in almost real time allows quick reactions to events in the field. Telemetry control allows to intervene with assets such as pumps and allows to remotely switch pumps on or off depending on the circumstances.
Telemetry is used to transmit data in real time to server-based databases and applications with interfaces allowing monitoring and control. Server-side data storage and interpretation offers increased pool reliability. Additional data points, such as weather telemetry locally gathered or from Internet sources, can offer increased refinement of the control functions, reducing the requirement for consumables to manage water quality. Telemetry is also used to monitor health and usage of local equipment in the pump house. A properly designed telemetry and control system can offer additional benefits in professional management of maintenance contracts, with significant reduction in labor cost per client. PCFR SAS's PoolCop / PoolCopilot technology is an example of this approach to swimming pool management and control using telemetry transmitted from the pump house using the client's Internet service.
Defense, space and resource exploration
Telemetry is used in complex systems such as missiles, RPVs, spacecraft, oil rigs, and chemical plants since it allows the automatic monitoring, alerting, and record-keeping necessary for efficient and safe operation. Space agencies such as ISRO, NASA, the European Space Agency (ESA), and other agencies use telemetry and/or telecommand systems to collect data from spacecraft and satellites.
Telemetry is vital in the development of missiles, satellites and aircraft because the system might be destroyed during or after the test. Engineers need critical system parameters to analyze (and improve) the performance of the system. In the absence of telemetry, this data would often be unavailable.
In rocketry, telemetry equipment forms an integral part of the rocket range assets used to monitor the position and health of a launch vehicle to determine range safety flight termination criteria (Range purpose is for public safety). Problems include the extreme environment (temperature, acceleration and vibration), the energy supply, antenna alignment and (at long distances, e.g., in spaceflight) signal travel time.
Flight test programs typically monitor data collected from on-board flight test instrumentation over a PCM/RF link. This data is analyzed in real time for safety reasons and to provide feedback to the test pilot. Challenges to telemetering this data include fading, multipath propagation and the Doppler effect. The bandwidth of the telemetry link is often insufficient to transfer all data acquired; therefore, a limited set is sent to earth for real-time processing while an on-board recorder ensures the full data set is available for post-flight analysis.
Telemetry was an important source of intelligence for the United States and UK when Soviet missiles were tested; for this purpose, the United States operated a listening post in Iran. Eventually, the Russians discovered the U.S. intelligence-gathering network and encrypted their missile-test telemetry signals. Telemetry was also a source for the Soviets, who operated listening ships in Cardigan Bay to eavesdrop on UK missile tests performed in the area.
In factories, buildings and houses, energy consumption of systems such as HVAC are monitored at multiple locations; related parameters (e.g., temperature) are sent via wireless telemetry to a central location. The information is collected and processed, enabling the most efficient use of energy. Such systems also facilitate predictive maintenance.
Many resources need to be distributed over wide areas. Telemetry is useful in these cases, since it allows the system to channel resources where they are needed; examples of this are tank farms in gasoline refineries and chemical plants.
Telemetry also is used for patients (biotelemetry) who are at risk of abnormal heart activity, generally in a coronary care unit. Such patients are outfitted with measuring, recording and transmitting devices. A data log can be useful in diagnosis of the patient's condition by doctors. An alerting function can alert nurses if the patient is suffering from an acute (or dangerous) condition.
A new and emerging application for telemetry is in the field of neurophysiology, or neurotelemetry. Neurophysiology is the study of the central and peripheral nervous systems through the recording of bioelectrical activity, whether spontaneous or stimulated. In neurotelemetry (NT) the electroencephalogram (EEG) of a patient is monitored remotely by a registered EEG technologist using advanced communication software. The goal of neurotelemetry is to recognize a decline in a patient's condition before physical signs and symptoms are present.
Neurotelemetry is synonymous with real-time continuous video EEG monitoring and has application in the epilepsy monitoring unit, neuro ICU, pediatric ICU and newborn ICU. Due to the labor-intensive nature of continuous EEG monitoring NT is typically done in the larger academic teaching hospitals using in-house programs that include R.EEG Technologists, IT support staff, neurologist and neurophysiologist and monitoring support personnel.
Because of the recent advance involving microprocessor speeds, software algorithms and video data compression, private companies such as CortiCare have emerged to now make it possible for hospitals of all sizes to record and monitor the continuous digital EEG of multiple critically ill patients simultaneously without the necessity of staffing internal resources.
Neurotelemetry and continuous EEG monitoring provides dynamic information about brain function that permits early detection of changes in neurologic status, which is especially useful when the clinical examination is limited.
Fishery and wildlife research and management
Telemetry is used to study wildlife, and has been useful for monitoring threatened species at the individual level. Animals under study can be outfitted with instrumentation tags, which include sensors that measure temperature, diving depth and duration (for marine animals), speed and location (using GPS or Argos packages). Telemetry tags can give researchers information about animal behavior, functions, and their environment. This information is then either stored (with archival tags) or the tags can send (or transmit) their information to a satellite or handheld receiving device.
At a 2005 workshop in Las Vegas, a seminar noted the introduction of telemetry equipment which would allow vending machines to communicate sales and inventory data to a route truck or to a headquarters. This data could be used for a variety of purposes, such as eliminating the need for drivers to make a first trip to see which items needed to be restocked before delivering the inventory.
Retailers also use RFID tags to track inventory and prevent shoplifting. Most of these tags passively respond to RFID readers (e.g., at the cashier), but active RFID tags are available which periodically transmit location information to a base station.
Telemetry hardware is useful for tracking persons and property in law enforcement. An ankle collar worn by convicts on probation can warn authorities if a person violates the terms of his or her parole, such as by straying from authorized boundaries or visiting an unauthorized location. Telemetry has also enabled bait cars, where law enforcement can rig a car with cameras and tracking equipment and leave it somewhere they expect it to be stolen. When stolen the telemetry equipment reports the location of the vehicle, enabling law enforcement to deactivate the engine and lock the doors when it is stopped by responding officers.
In some countries, telemetry is used to measure the amount of electrical energy consumed. The electricity meter communicates with a concentrator, and the latter sends the information through GPRS or GSM to the energy provider's server. Telemetry is also used for the remote monitoring of substations and their equipment. For data transmission, phase line carrier systems operating on frequencies between 30 and 400 kHz are sometimes used.
Telemetry is used in testing hostile environments which are dangerous for humans to be present . Examples include munitions storage facilities, radioactive sites, volcanoes, deep sea, and outer space
Telemetry is used in many battery operated wireless systems to inform monitoring personnel when the battery power is reaching a low point and the end item needs fresh batteries.
- Leaf Sensor
- Machine to Machine (M2M)
- MQ Telemetry Transport (MQTT)
- Portable telemetry
- Reconnaissance satellite, tapping of communications routing or switching centers (e.g., Echelon)
- Remote monitoring and control
- Remote sensing
- Remote Terminal Unit (RTU)
- Wireless sensor network
- "Telemetry: Summary of concept and rationale". NASA. NASA Technical Reports Server. Retrieved 26 September 2011.
- Mary Bellis "Telemetry"
- Bakshi et al., pages 8.1-8.3
- Mayo-Wells, "The Origins of Space Telemetry", Technology and Culture, 1963
- Joachim & Muehlner, "Trends in Missile and Space Radio Telemetry" declassified Lockheed report
- Molotov, E. L., Nazemnye Radiotekhnicheskie Sistemy Upravleniya Kosmicheskiymi Apparatami
- "Schlumberger MWD & LWD Services". Schlumberger Limited. Retrieved 4 June 2012.
- Mayer and Chalfant, “Trends in Aeronautical Flight Test Telemetry”, Aero India, 2009
- "Marine Wildlife Telemetry". Pinniped Ecology Applied Research Laboratory. Retrieved 30 January 2012.
- "What Is Telemetry?". Pinniped Ecology Applied Research Laboratory. Retrieved 25 July 2011.
- International Foundation for Telemetry
- IRIG 106 — Digital telemetry standard
- The European Society of Telemetering